92-005721-XXX REV.E-04 – TRENTON SBC VGA ETHERNET CABLES, PGA370, 20-005722-04

General
10/100Base-T Ethernet Interface (Not available on Basic Models): Implemented using Intel 82559 and operates in 20Base-T and 100Base-TX Fast Ethernet modes, compliant with IEEE 802.3 and PCI Local Bus 2.1 Specifications
AGP VGA(Not available on Basic Models): 69000 HiQVideo/graphic accelerator integrates 2MB of high-speed SDRAM frame buffer memory into the chip
Battery: A built-in lithium battery is provided, for ten years of data retention for CMOS memory
BIOS (Flash): Hi-flex AMIBIOS with built-in advanced CMOS setup
Bus Interfaces: ISA and PCI Local Bus Compatible
Bus Speed & System Memory: Intel Pentium III – 100MHz; Intel Celeron – 66MHz or 100MHz
Bus Speed-ISA: 8.33MHz
Bus Speed-PCI: 33MHz
Cache Memory: For Pentium III the processor includes and integrated on-die, 256K 8-way set L2 cache and also includes a 16K L1 cache and 16K L1 data cache; For Celeron processors, a 128K unified, non-blocking L2 cache.
Data Path: DRAM/Memory – 64-bit; ISA Bus – 16-bit; PCI Bus – 32-bit; Video – 64-bit
DMA channels: Fully PC compatible with seven DMA channels, each supporting type F transfers
DRAM Memory: 2 DIMM sockets supporting auto dectection of memory up to 512MB of SDRAM for the 440BX or up to 1GB of SDRAM for the 440GX; minimum memory size is 8MB
ECC: Supported via BIOS setting for multiple-bit error detection and correction of all errors confined to a single nibble
Enhanced Parallel Interface: PC/AT compatible bi-directional parallel port and supports EPP mode and ECP mode
Floppy Drive Interface: Two floppy disk drives supported; Drives can be 360K to 2.88MB, in any combination
Humidity: 5% to 90 % non-condensing
Interrupts: Fully PC compatible with interrupt steering for PCI plug and play compatability
Keyboard Interface: Compatible with an AT-type keyboard
Memory Hole: Support a 1MB memory hole option at 512KB-640KB or 15MB-16MB
Operating Temperature: 0 to 60 Degrees Celsius, 0 to 55 Degrees Celsius for 700MHZ Intel Pentium III and above
PCI Enhanced IDE Ultra DMA/33 Interface (Dual): Capable of supporting two IDE Type 4 disk drives each in a master/slave configuration, and supports Ultra DMA/33 with SDRAM mode transfers up to 33MB/s
PCI Local Bus Interface: Compliant with PCI Local Bus 2.1 Specifications
PCI Ultra Wide SCSI (Not available on Basic Models): PCI Bus Master device sipporting Ultra Wide SCSI data transfer up to 40MB/s and bursts data to the host at full speed
Power Fail Detection: A hardware reset is issued when on board +5 voltage drops below 4.75 volts; In addition, if the 3.3V Monitor jumper is enabled, a reset is issued if 3.3V is below tolerance
Power Requirements: Intel Pentium III-100MHz FSB: 850MHz – +5V, 7.7Amps; +12V, <100mAmps; -12V, <100mAmps; 800MHz -+5V, 7.1Amps; +12V, <100mAmps; -12V, <100mAmps -or- Intel Celeron: 733MHz - +5V, 6.5Amps; +12V, <100mAmps; -12V, <100mAmps; 667MHz -+5V, 6.1Amps; +12V, <100mAmps; -12V, <100mAmps; 633MHz -+5V, 5.6Amps; +12V, <100mAmps; -12V, <100mAmps Processors: Intel Pentium III(FC-PGA)microprocessor - 1.0GHz, 900MHZ to 650MHz, 600EMHz to 500EMHz with 256k cache and a 100MHz FSB; Intel Celeron microprocessor - 900MHz or 850MHz with 128k cache and a 100MHz FSB,800MHz to 333MHz with 128K cache and a 66MHz FSB PS/2 Mouse Interface: Compatible with PS/2 type mouse Serial Interface: Two high-speed FIFO (16C550) serial ports with independently programmable baud rates supported Storage Temperature: -40 to 70 Degrees Celsius System & Memory Buses: Intel 440BX/GX ASPset supports the system and memory buses at both 66MHz and 100MHz System Hardware Monitor: YES USB: Supports two USM ports for serial transfers at 12 or 1.5Mbit/sec Watchdog Timer: 2 levels of enable